12-inch Standard Electric Brake Magnet

Part No: MAGNET-12 Category:
Part No: MAGNET-12 Category:

Price

$20.00 Inc.GST

Shipping

Select delivery location

Couplemate accepts PayPal, Visa and Mastercard.

12-inch Standard Electric Brake Magnet

Caravan standard 12-inch electric brake magnets are suited to all-electric brake systems except for older round magnet brake systems.

Brake Magnets and the difference between 10-inch and 12-inch

  • 10-inch brake magnets have Green leads, except for Dexter Magnets, which have black leads.
  • 12-inch brake magnets have white leads, except for Dexter Magnets, which have black leads.
  • 12-inch magnets sold with green leads are 10-inch magnets with less copper wire and lower braking capacity.
12-inch electric brake magnets are used to actuate the brakes on trailers. A typical setup consists of two electromagnets attached to the backing plate of the brake assembly. When the brake controller is activated, it sends an electric current to the magnets, which causes them to attract each other. This pulls the brake shoes against the brake drum, stopping the trailer.

How to check magnet wear

  • Check the four small holes on top of the magnet.
  • These holes are warning indicators that display magnet wear.
  • Extreme magnets wear if there are no holes or fewer than four holes.
  • When the face of the magnet hole has worn, then it is time to replace the magnet.

Electric Brake Magnet in our Range of Products

Magnet Wear Key Features

  • Wear holes are at 3 pm, 6 pm, 9 pm, and 12.
  • Magnets draw approximately 3.2 amps each.
  • Wires can be connected either positively or negatively.

Once connected, magnets have polarity. The face is either the north or south pole. If the positive and negative writes are transposed, there is little difference in the braking efficiency.

Once worn, copper begins to become exposed. Subsequently, an open electric circuit will render the brakes inoperable.

Braking Tips

  • Bed new magnets into position to achieve 100% braking efficiency.
  • The magnet face has a shiny finish.
  • This finish must be scuffed up during the initial stages of breaking before your magnets become 100% effective.

Why can’t I run the electric cable across my axle?

The voltage drop increases exponentially according to the length of the cable. Larger or shorter cable lengths defeat the voltage drop.

  • Rundown each chassis rail = 6mtr @ 6.4 Amps per pair of magnets = 5.62mm cable size
  • Run down the chassis trailer (inside) = 6 meter + 2 mete (8mtr) @ 6.4 Amps per pair of magnets = 7.5mm cable size

To escape voltage drop, run the cabling down the chassis rail.

What is the best Electric Brake Controller?

We recommend using a Tekonsha Primus, Prodigy, or a Chassis Mounted brake controller (Queensland and NT Only).

Do not power electric brakes from the brake light circuit for chassis-mounted brake systems.

Incandescent brake light circuits provide only 21 watts of power and perform the function of a control circuit for chassis-mounted controllers. If you have purchased a caravan or camper with brakes wired into the brake lights, the braking system works at less than 25% of its efficiency.

Wire all brake controllers from the battery. In most cases, the brake controller has a relay powered by the brake lights.

Brake Controllers use Brake Lights to Power Brakes.

If brake lights are used to power brake controllers, significant voltage losses occur, resulting in brakes operating at less than 25% capacity.

Brake magnets need 3.2A each. The manufacturer wires no vehicle to supply this load through rear tail lights.

It is permissible to wire chassis controllers from the onboard battery in the caravan.

Why do off-road magnets last longer?

  • The steel magnet arm causes the steel magnet on a standard highway magnet to rattle, causing wear.
  • The plastic insert on the off-road magnet prevents the same wear under the same conditions.

It is durable and reliable and will not disappoint even in the most challenging terrain.

Difference between Highway and Offroad Magnets

  • The Electric Highway brake kit uses a magnet retaining clip to hold the magnet into position on the magnet arm.
  • The off-road electric brake magnet uses a RUBBER BAND to hold the magnet in position on the magnet arm.

The rubber band breaks on first use and relies on the return spring to hold the magnet.

The left-side and right-side magnets are not interchangeable.

  • The left-hand side is the passenger’s side
  • The right-hand side is the driver’s side

The rubber band holds the magnet in position to allow drum installation onto the axle profile, then tightens.

If the magnet needs replacing or upgrading from a standard magnet, then replacing the whole backing plate may be wise. 

Offroad Electric Brake Magnets

Electric Brake Magnet Comparison

12-inch Electric Backing Plate prices here.

The magnet in the third image was a standard magnet used on corrugated.

All 12-inch OffRoad Electric Brake Magnets have a plastic insert that prevents the magnet arm from causing damage to the magnet from corrugated road vibrations. (Image 2).

As a result, offroad magnets continue to show no wear tens of thousands of miles on corrugated roads.

Safety Chain Checks

Necessary safety checks or tandem wheel caravans. With the chains attached to your vehicle, push your trailer back to the extremity of the chains.

Finally, did the pin on your breakaway kit disengage?

Caravan Electric Brake Magnets

Additional information

Weight0.4 kg
Dimensions10 × 5 × 4 cm

Our Service Lifetime Warranty

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Couplemate™ is a manufacturer and vendor of high-quality towing, trailer, and caravan components. Couplemate™ Core Goods and Custom Work are guaranteed to be free of defects for the service lifetime of the product when used as intended.

Warranties are non-transferrable and Couplemate™ requires satisfactory proof of purchase prior to issuing a remedy. The full Couplemate™ Warranty Policy can be found in the Terms & Conditions: Section 8 – Consumer Guarantees & Warranty.

Warranties are in addition to your rights under the Australian Consumer Law. If something is wrong with your order, please contact our team.

60-Day Returns

After 60 years of experience, we know that life has its unpredictable moments.

All Couplemate™ orders (online, over the phone, or in-store) have a 60 day period for change-of-mind returns and exchanges. There are some items that can’t be returned and some returns may incur a 15% restocking fee.

You can view our full policy for change-of-mind returns here.

Reviews

    Be the first to review “12-inch Standard Electric Brake Magnet”

    Your email address will not be published. Required fields are marked *

    High-Quality Trailer Parts

    Couplemate™ Core Range

    Couplemate Trailer Parts.

    About Us

    Contact Info

    Trade & Wholesale

    Australian Made

    Australian Made

    FAQ